AVR ISP Shield

I’m not getting paid to say this, but I bought this ISP Shield for Arduino and found it to be convenient:

DIYMORE AVR ISP Shield attached to an UNO, with chip loaded.

This setup is the same as programming using two Arduino boards and the Arduino ISP sketch, but a more compact and convenient, since you don’t have to figure out where the wires go, and you can clip the chip into the ZIF socket.

I like this better than the other programmers I have used, at least for burning 328P chips. To use it, you must (one time) load the Arduino as an ISP sketch onto the 328P chip, and then afterwards attach the shield. When burning chips with avrdude, use the stk500v1 programmer type.

Shield disconnected from UNO

1 thought on “AVR ISP Shield”

Leave a Reply to AlaskaLinuxUser Cancel reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s